Step 9 - Multiple Battery Installations - Energizer HOMEPOWER HP-6S Installation Manual

2.4G Wi-Fi
The Energizer Homepower HP-6M also supports 2.4 GHz Wi-Fi connectivity. If this method is being used, the Wi-Fi
configuration shall be carried out using the Energizer Homepower Installer App.
Antenna (Wi-Fi & 4G)
The Energizer Homepower HP-6M is supplied with a dual-purpose external antenna that supports both Wi-Fi and
4G/LTE band. The antenna module also serves as a hole blocker, therefore it must be installed regardless of the
chosen connection method.
It must be installed on the same side as the entry points of the AC connection. Follow instructions below for
right side installation.
Fig. 23. Installing Antenna Module
For left side installation follow the same steps as the right-side installation with the exception of adding the
antenna extension cable, as the cable path to the antenna port is much shorter when installed on the left.
A: Remove lock nuts from B: Insert antenna module
Antenna Module into side of unit with angled
Ethernet
edge facing outwards
C: Tighten lock nuts
To connect via Ethernet a communication cable must be run from the Ethernet port directly to a router within the
home that is connected to the internet.
A: Bring Ethernet cable through M25 conduit connector into connection zone
B: Punch hole in rubber grommet and push cable through
C: Plug RJ45 connector into Ethernet port
Fig. 24. Connecting Ethernet Cable
V23-00220
6
Energizer Homepower HP- Series - Installation Manual
D: Join antenna extension cable
E: Punch hole in rubber grommet and push cable through
F: Screw end onto antenna connection point
28 © Energizer 2022
6
Energizer Homepower HP- Series - Installation Manual
Blocking Openings
Block all unused threaded openings on either side using the aluminium hole blockers provided to ensure a
water-tight seal.
Fig. 25. Installing Hole Blockers
Step 9 – Multiple Battery Installations
NOTE: Steps 9 & 10 apply only to the installation of the Sub Units (HP-6S). If the Energizer
Homepower (HP-6M/HP-6S) is limited to just the Main Unit (HP-6M), please skip to Section 6
(pg. 31) to finish & demonstrate the installation.
Sub Units (HP-6S) are always installed on the opposite side to the AC connections of the Main Unit (HP-6M),
e.g. if the AC cables are fed in through the right side of the Main Unit, the Sub Units must be installed on the
left side of the Main Unit, and vice versa as shown below. Please refer to Step 3 on pg. 15 for placement and
mounting instructions.
Fig. 26. System Configurations
V23-00220 29 © Energizer 2022