Step 6 - Electrical Connections(Ac Side) - Energizer HOMEPOWER HP-6S Installation Manual

Before making the connections, start by securing the unit to the bracket by installing the locking bolt as
shown below.
Fig. 15. Installing Locking Bolt
Step 6 – Electrical Connections (AC side)
Electrical connections, including AC Isolator requirements for the Energizer Homepower HP-6
Series system must be carried out as per the recommended local & national electrical regulations.
Choosing the Side of Entry
Cables may enter the Main Unit from either the left or the right via the 3x M25 threaded openings. Carefully
consider which side is going to provide a shorter and neater cable path back to the main switchboard and run
cables accordingly.
Fig. 16. Cable Entry Points
V23-00220
6
Energizer Homepower HP- Series - Installation Manual
Cable
entry
points
24 © Energizer 2022
6
Energizer Homepower HP- Series - Installation Manual
Connecting the Grid AC
Install a circuit breaker rated to handle the inverter max current, within the switchboard (or load centre). Screw
in the M25 conduit adaptor supplied, then run the AC power cables (Line, Neutral & Earth) from the switchboard
through medium duty or heavy duty corrugated conduit into the HP-6M Grid Terminals and common earthing point
located within the connection zone.
Fig. 17. AC Connection (Grid)
Connecting the Backup AC (if applicable)
In the absence of grid power or grid-failure, the Main Unit (HP-6M) has the ability to supply power to essential
loads (not exceeding 3.6 kW/16 A) using a dedicated UPS function. Install a circuit breaker rated to handle the
inverter Backup rated current within the switchboard (load centre). Screw in the M25 conduit adaptor supplied,
then run the AC power cables (Line, Neutral & Earth) from the switchboard through medium duty or heavy duty
corrugated conduit into the HP-6M Grid Terminals and common earthing point located within the connection zone.
Fig. 18. AC Connnection (Backup)
V23-00220 25 © Energizer 2022