Energizer HOMEPOWER HP-6S Installation Manual page 10

When adding Sub Unit(s), it is strongly recommended to install the HP-6M & 6S modules adjacent to one another
using the spacing guide provided. All cables provided with the Sub Unit (HP-6S) cater to this spacing exactly.
However, there is no mandatory sequence for HP-6M/6S placement and for site-specific obstructions (such as
stationary objects, pipes, window ledges etc.), ensure the Sub Unit is installed within a maximum distance of 5m
from the Main Unit.
The bracket has provision for accommodating M6, M8 or M10 fasteners using appropriately sized holes. Select
the appropriate fastener based on the wall material and local building codes. The Energizer Homepower HP-6
Series units can be mounted on a variety of surfaces including wood, metal or concrete walls. Please follow the
recommendations for each surface below:
• Wood & metal stud walls - use a minimum of six (6) fasteners, one for every corner, and a further two in the
next most suitable positions (as shown in Fig. 8).
• Concrete or masonry walls - use a minimum of four fasteners, one for every corner (as shown in Fig. 8).
• Follow the arrows on the bracket to ensure correct orientation.
To ensure the correct position of the HP-6M wall bracket, refer to Fig. 9 that illustrates the position of the wall
bracket in relation to the unit itself.
1244mm
210mm
Wall bracket for HP-6M (Main Unit)
420mm
Fig. 8. Wall bracket for HP-6M (Main Unit) & HP-6S (Sub Unit)
Use a spirit level to ensure the bracket is level and carefully mark the holes to be used. Drill the holes and install the
wall-mount bracket and ensure the fasteners hold the bracket firmly in place.
V23-00220
6
Energizer Homepower HP- Series - Installation Manual
Wall bracket for
HP-6S (Sub Unit)
18 © Energizer 2022
6
Energizer Homepower HP- Series - Installation Manual
When installing the first Sub Unit (HP-6S) use the Sub to Main Spacer Mate to mark the location of the Sub Unit
bracket in relation to the Main Unit as shown in Fig. 9.
SUB to MAIN
Alignment Tool
SUB to MAIN
Alignment Tool
Fig. 9. Sub to Main Spacer Mate
SUB to SUB
Alignment Tool
When installing consecutive Sub Units (HP-6S) use the Sub to Sub Spacer Mate to mark the location of the Sub
Unit bracket in relation to the adjacent Sub Unit as shown in Fig. 10.
SUB to SUB
Alignment Tool
Fig. 10. Sub to Sub Spacer Mate
V23-00220 19 © Energizer 2022