Step 5 - Accessing The Main Unit "Connection Zone - Energizer HOMEPOWER HP-6S Installation Manual

Installing the battery onto the wall-mount bracket using lifting equipment is recommended. Adjust the height
of the battery using the lift equipment until they are slightly above the marked areas, then utilising the "Slot"
position guide stickers (refer to Fig. 12) located on the side of the mounting rails, align the top tooth of the
bracket with the slot position as indicated. Then ensuring the teeth are aligned with the slots, both horizontally
and vertically, push the unit onto the bracket and gradually lower it into place until it fully engages. Sticker may
be peeled off after mounting.
Fig. 12. Slot Position Guide
Step 5 – Accessing the Main Unit "Connection Zone"
Lift up the Magna-Flap on the HP-6M as shown in Fig. 13. and remove the Installer Access Panel (IAP) by
removing the 4x M4 socket head screws using a 2.5mm Allen wrench, gently prize it out by gripping it from the
left and right edges.
Fig. 13. Removing Main Unit IAP
V23-00220
6
Energizer Homepower HP- Series - Installation Manual
22 © Energizer 2022
6
Energizer Homepower HP- Series - Installation Manual
Getting to Know Your Main Unit (HP-6M) Connection Zone
Once you have removed the IAP, you will gain access to all of the parts required for the installation. Please refer
to the guide below to get familiar with the various parts. Please note that ports G, H & M are strictly for use by a
qualified Energizer Homepower Technician.
Fig. 14. Main Unit Connection Zone
V23-00220 23 © Energizer 2022