Chapter 5 - V.25Bis Commands - Multitech MT5600BA-V92 At Commands Reference Manual

Chapter 5 – V.25bis Commands
Note: These commands can be used with the MT5600BA only.
The V.25bis commands control synchronous communications between the host and the modem using the HDLC or
character-oriented protocol. Modulation depends on the serial port rate and setting of the transmitting clock source.
These commands apply to modems that support synchronous communications.
Command: CIC
Description:
Command: DIC
Description :
Command: CRNs Call Request Number
Description:
Values:
Command: CRIs Call Request Identification
Description:
Values:
V.25bis Number Format:
Command: PRNx;s Program Number
Description:
Values:
Command: CRSx Call Request Address
Description:
Values:
Command: PRIa;s Program Identification Number
Description:
Command: RLD
Description:
Multi-Tech Systems, Inc. AT Commands Reference Guide (S000273F)
Connect Incoming Call
Answers an incoming call. Values: n/a
Disregard Incoming Call
Disregards current incoming call. Values: n/a
Used to dial a number
s =dial string (0-9, *, #, :, <, =, P, T)
Used to dial a number
s =dial string (0-9, *, #, :, <, =, P, T)
0-9 Dialing Digit
: Wait tone
< Pause
= Separator
P Dialing to be continue in Pulse mode
T Dialing to be continue in DTMF
Used to store dial string s in location x.
x=(0-3)
s = dial string (0-9, *, #, :, <, =, P, T)
Recalls dial string to dial from location x.
x=(0-3)
Dummy Command (just returns VAL).
List Request of Delayed Call Number
Returns current listing of Delayed numbers. Values: n/a.
Chapter 5 – V.25bis Commands
41