Command:
-QCPC Force Full Startup Procedure Next Connection
Description:
Result Code:
Command:
-QCPS Enable Quick Connect Profile Save
Description:
Values:
Result Codes:
Report Commands:
Multi-Tech Systems, Inc. AT Commands Reference Guide (S000273F)
This command causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt, the modem
will select the startup procedure as defined by the +PQC command. If a shortened
startup procedure is enabled by +PQC, then the quick connect profile will also be
updated on the next connection attempt.
Syntax: -QCPC
OK
ERROR Otherwise
This command controls whether or not the modem will save the generated quick
connect profile.
Syntax: -QCPS=<value>
0, 1
<value>
Decimal number corresponding to the desired operation.
0
Do not allow the quick connect profile to be saved.
1
Allow the quick connect profile to be saved. Default
OK 0 or 1 in V.92 Mode (+MS=V.92) and quick connect is enabled (+PSS = 0)
ERROR Otherwise
-QCPS?
Reports selected value
-QCPS=? Reports supported range of parameter values
Chapter 2 – AT Commands
18