Lifespan Of Your Lumilisse® Hair Remover; Lifespan; Troubleshooting; My Lumilisse® Hair Remover Won't Start - Conair Lumilisse G960 Series Instructions Manual

Avoid exposing the treated areas to sun. Protect your skin with a
sunscreen throughout the treatment and for at least two weeks
after the last session with your Lumilisse® Hair Remover.
Do not use scented cream or deodorant on the treated areas after
your sessions.
Side effects and complications
Some users may notice a change in pigmentation following a
treatment with the Lumilisse® Hair Remover. These effects, if they
appear, are generally slight and temporary.
If you experience complications, stop using the appliance
immediately and contact your healthcare provider.
8. Lifespan of your Lumilisse® Hair Remover

8.1 Lifespan

With an exceptionally long life, the Lumilisse® Hair Remover flash lamp releases all its
light pulses without a decline in energy.
When the unit is at the end of its life, the ON/OFF indicator light will flash orange. The
unit is now permanently disabled.
Do not use the unit if large stains appear inside the flash
lamp or if the application surface is broken. Contact Conair®

Customer Service.

9. Troubleshooting

9.1 My Lumilisse® Hair Remover won't start
Ensure the adapter is properly connected to your Lumilisse® Hair Remover and plugged
into a wall outlet.

9.2 There are no pulses when I press the release mechanism

Ensure that the application surface is evenly and firmly in contact with your skin and that the
Ready indicator light is flashing; this indicator light guarantees that the unit is in full contact
with your skin. For your safety, the release switch will be able to release a pulse only if the
application surface is firmly pressed against your skin.
Make sure the Ready light is lit.
• If after 10 seconds the Ready light is still off, switch your Lumilisse® Hair Remover off
and on again by pressing the ON/OFF button twice.
• If the problem persists, contact Conair® customer service.
Make sure the ON indicator light is lit.
• If it is lit, switch your Lumilisse® Hair Remover off and on again by pressing the
ON/OFF button.
• If the problem persists, contact Conair® Customer Service.
The ON/OFF indicator light is red.
• The unit has switched to the safety mode because it has detected that it is overheated
or there is a critical problem. Under circumstances like these, switch the unit off and
allow it to cool for 15 minutes before switching it on again.
• If the problem persists, contact Conair® Customer Service.
47