Operating Modes - Conair Lumilisse G960 Series Instructions Manual

Only if there are absolutely no side effects following the previous session, you may in-
crease the power level manually to increase effectiveness. Please refer to the chart on
page 17 for intensity levels recommended for your phototype. Do not increase intensity
by more than one level per session, and do not surpass the level recommended for your
skin type.
If you experience any discomfort, reduce to the previous power level.
NOTE: If a non-authorized level has been reached using the manual control with respect
to the skin color determined by the Skin Sensor, the power level LED indicator in question
will flash 3 times to indicate a non-authorized level. We therefore recommend manually
reducing the power level to an authorized level.

6.4 Operating modes

The Lumilisse® Hair Remover features two operating modes: Precision mode and Glide
mode. The two modes differ in how the light pulse is triggered. In Precision mode, you
manually trigger each pulse by pressing the trigger button. In Glide mode, you press and
hold the trigger button as you slide the unit across your skin, with flashes being automati-
cally released at a rate preset for each intensity level. Glide mode allows you to move a
little faster.
Start out in Precision mode. If you have successfully used Precision mode several times
and feel comfortable with your experience level, you can try the Glide mode, being careful
not to overlap treatment areas.
A. Precision mode
Precision mode allows you to safely treat the more hard-to-reach, sensi-
tive areas of the body (face, armpits, bikini line, etc.).
To treat the face, fit the special facial attachment to the top of the device
and follow the safety precautions described in the chapter on facial depila-
tion with the Lumilisse® Hair Remover .
Follow these steps:
See steps 1 to 8 of chapter 6.3, "Treatment with the Lumilisse® Hair Remover."
B. Glide mode
In Glide mode, the light pulses from your Lumilisse® Hair Remover are re-
leased automatically and constantly without any additional actions being
necessary (36 light pulses per minute, constantly, at level 1).
Follow these steps:
1. To activate Glide mode, repeat steps 1 and 6 of chapter 6.3, "Treatment with the
Lumilisse® Hair Remover." Then correctly place the application surface of the Lumilisse®
Hair Remover against your skin while holding down the trigger button on the device.
2. Glide the Lumilisse® Hair Remover over your skin without interruptions, in a slow, con-
tinuous movement, without making any up or down movements.
44