Treatment With The Lumilisse® Hair Remover - Conair Lumilisse G960 Series Instructions Manual

If your skin does not react correctly to the test (FIG. 18), if you experience any abnormal
reactions or discomfort after 48 hours, perform a second test at intensity level 1, whatever
your phototype, without considering the Skin Sensor, and wait 48 hours (FIG. 19-20-21).
- If you react correctly to this second test, proceed with the first treatment session,
manually selecting level 1.
- If your skin does not react correctly to this second test, we recommend not using the
appliance.
For subsequent sessions, if there is absolutely no discomfort or side effects, you may
gradually increase the power level over the sessions, with respect to the table below and
using the intensity choice log to help you;
- Phototype I:
- Phototype II:
- Phototype III:
- Phototype IV:
6.3 Treatment with the Lumilisse® Hair Remover
We recommend that you always use the Skin Sensor on your skin before each depilation
session and each change to the treatment area. Remember that different areas on the
same limb may be different skin colors (e.g., inside wrist and top of underarm). When you
first start out using the Lumilisse® Hair Remover, start on your body, not your face, using
the body attachment until you gain confidence using the unit.
1. Plug the adapter cord into the power jack on the handle of the Lumilisse® Hair Remover
(FIG. 1 on the Quick Start Usage Guide included).
2. Plug the other end of the adapter into a power outlet.
> The ON/OFF button turns on and is orange in color (FIG. 2).
3. Switch on the unit by pressing the ON/OFF button (FIG. 3).
> The ON/OFF button turns green.
> The power level 1 LED indicator is on. Level 1 is programmed by default when the
unit is switched on (FIG. 4).
4. Place the unit Skin Sensor on the area of skin where you wish to perform treatment
(FIG. 12).
> The intensity level LED indicator(s) switch on and flash, showing that the unit
has successfully detected the phototype of the area of skin to be depilated
and has adjusted the power level automatically (FIG. 13).
5. Press once on the trigger to confirm (FIG. 14).
> The intensity level LED indicator(s) stop flashing (FIG. 15).
6. Position the application surface on the area of skin detected and keep the application
surface still, in position, to ensure total contact.
> The Ready LED flashes green when the unit is correctly positioned on the skin
and ready to release a light pulse (FIG. 16).
7. Press the trigger button to release a light pulse onto the skin (FIG. 17).
NOTE: You may feel a slight hot sensation and tingling. This is normal.
8. Move the application surface to another area of skin and press the trigger button to
release another light pulse. Take care not to overlay the light pulses.
43