Conair GMT7171WCSC Instruction Booklet

gettIng Started:

outlInIng your beard
1. It is always best to
begin with a clean, slightly
damp beard.
2. After you have combed
through your beard in the
direction it grows naturally, you will want to
outline the desired shape, beginning under
your jawline.
3. Begin defining your beard's shape under
your chin and work upward on each side
of your face toward your ears. Then define
the upper outline of your beard across your
cheeks, past your sideburns, and toward
your hairline.
now you're ready to trIm
your beard
1. Your trimmer adjusts to five positions so you
can have a beard length from 1/8" (shortest)
to 5/8" (longest).
2. To use the 5-position comb, slide the unit
over the trimmer blades and snap it down
into position. At first, until you become familiar
with the adjustments, use the longest trim
setting (5/8").
(You can always go back and make your beard
a little shorter.)
3. Begin trimming your beard using smooth,
even strokes. Start with your sideburns
and work downward toward your chin.
(Never attempt
trim against
natural growth of your
beard because the hair
will be cut too short.)
4. If you decide you
want a closer trim, you can now adjust the
5-position comb attachment to a shorter set-
ting (such as 1/2" or 3/8") and go over your
beard again until you achieve the desired
length.
blendIng the JawlIne
1. The Three Jawline Attachments will help
you to achieve a neat, finished trim under
your chin. To
use one of the
attachments,
press it down
over the trim-
mer blades until it clicks into position.
2. Hold the trimmer in an upright position
and begin trimming under your jawline, using
short, even strokes.
3. After your beard is blended, turn off the
trimmer and remove the attachment by gently
pulling up on tab.
to trIm your muStache
1. For best results, start with a clean, slightly
damp mustache.
2. Comb through your mustache in the
direction it grows.
3. Place the 5-position
comb over the trimmer
blades and snap it into
position. It is a good idea
to
the