Setting Up The Mail Server; Configuring The Faxfinder's Inbound Did Modem - Multitech FaxFinder FF110 Administrator User Manual

7. Setting Up the Mail Server

The FaxFinder uses a mail server to send, by email, call log reports to the administrator. An email is also
sent to the administrator each time the FaxFinder is powered up. In all cases, you must specify the
address of the mail server and the email address of the administrator. Some email servers require
authentication before allowing the FaxFinder access. In these cases, the FaxFinder unit must be
assigned a Server User Name and a password. If the mail server does not require authentication, the
bottom row of SMTP Configuration fields ("Server User ID," "Password," and "Retype Password") must
be left blank.
a. In the FaxFinder Administration screen, go to the SMTP Configuration fields.
b. Fill in the network IP address or domain name of your mail server.
c. At this point you should receive an email from your FaxFinder saying that the mail server address has
been updated. If you do not receive such an email, see item #2 "What if I don't get an email when I
set the mail server address?" in Chapter 10: Troubleshooting.

8. Configuring the FaxFinder's Inbound DID Modem

The FaxFinder's DID Modem directs inbound faxes to client email addresses.
a. In the FaxFinder Server software, go to the Modem Configuration screen.
b. Under Modem Configuration: Modem 1 (DID Modem), enter the values that match the
characteristics of your DID phone line in the fields provided. (See the section "Prerequisite: Ordering
the DID Line" on page 17.)
Multi-Tech Systems, Inc. FF110 FaxFinder Fax Server Admin User Guide
Chapter 3: Server Installation
26