Table of Contents
Advertisement
Symbol
2.6
Safety instructions during installation
Preliminary requirements
•
Make sure that there is no voltage on the AC input cables during the complete
installation procedure.
•
Keep unqualified personnel at a safe distance during installation.
•
Only use electrical wires of sufficient gauge and insulation to handle the rated
current and voltage demand.
•
Make sure that the load capacity of the grid is in accordance with the EVSE.
•
Earth the EVSE correctly. Refer to section 2.8.
•
Make sure that the wiring inside the EVSE is protected from damage and cannot
get trapped when you open or close the cabinet.
•
Make sure that water cannot enter the cabinet.
•
Protect the EVSE with safety devices and measures that the local rules specify.
•
If it is necessary to remove safety devices, immediately install the safety devices
after the work.
•
Put on the correct personal protective equipment. Refer to section 2.5.
2.7
Safety instructions during transport
Preliminary requirements
•
Make sure that the hoisting equipment or forklift truck can lift the EVSE safely.
Take into account the mass and the center of gravity of the EVSE.
9AKK108467A6997-EN | 003
Description
Safety shoes
Safety glasses
•
Installation engineer
•
Installation engineer
•
•
Safety
15
Advertisement
Table of Contents
