Reset The Evse After An Emergency; Charge Session; Charge An Ev; Start A Charge Session - ABB Terra 94 North America Operation And Installation Manual

6.3

Reset the EVSE after an emergency

Preliminary requirements
Procedure
1. Make sure that the situation is safe again.
2. Turn the emergency button clockwise to release it.
•
•
•
6.4

Charge session

6.4.1

Charge an EV

Preliminary requirements
Procedure
1. Park an EV in the parking space. Make sure that the connector of the EV charge
cable can reach the connector on the EV.
2. Energize the EV.
3. Start the charge session. Refer to section 6.4.2.
4. Stop the charge session. Refer to section 6.4.3.
6.4.2

Start a charge session

Preliminary requirements
Procedure
1. On the touchscreen, select the applicable
2. Remove the EV charge cable from the EVSE.
3. Connect the EV charge cable to the connector on the EV.
4. On the touchscreen, press the
5. If the touchscreen shows a message to authorize the charge session, do the
instruction that the touchscreen shows.
The EVSE charges the EV and shows the progress on the touchscreen.
9AKK108466A3703-EN | 001
• Owner
The EVSE starts.
The message disappears from the touchscreen.
The EVSE resumes the normal operation.
• Owner
• Owner
Note: If you skip this step, the EVSE selects the correct connector
automatically when you connect the EV charge cable to the EV.
connector button.
Start button.
Operation
59