Yamaha X MAX CZD300-A Owner's Manual page 94

Periodic maintenance and adjustment
1. Engine oil drain bolt
2. Gasket
TIP
Skip steps 5–7 if the oil filter element is
not being replaced.
5. Remove the oil filter element cover
by removing the bolts.
9
1
1. Bolt
2. Oil filter element cover
6. Remove and replace the oil filter
element and O-ring.
2 1
1. Oil filter element
2. O-ring
7. Install the oil filter element cover
by installing the bolts, then tight-
ening them to the specified
torque.
Tightening torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.4 lb·ft)
2
TIP
Make sure that the O-ring is properly
seated.
8. Install the engine oil drain bolt and
its new gasket, and then tighten
the bolt to the specified torque.
1
9. Refill with the specified amount of
2
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
Make sure that no foreign material
enters the crankcase.
10. Install and tighten the oil filler cap
9-12
Tightening torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 15 lb·ft)
the recommended engine oil.
Recommended engine oil:
See page 11-1.
Oil quantity:
Oil change:
1.50 L (1.59 US qt, 1.32 Imp.qt)
With oil filter removal:
1.60 L (1.69 US qt, 1.41 Imp.qt)
and its O-ring.
ECA24060