Titan TTB863MLT Manual page 7

TTB863MLT by TITAN
>This power tool is intended to function as a grinder,
sander, wire brush, polisher, carving or cut-off tool.
Read all safety warnings, instructions, illustrations
Failure to follow all instructions listed below may result
>
designed and recommended by the tool manufacturer.
Just because the accessory can be attached to your
power tool, it does not assure safe operation.
>The rated speed of the grinding accessory must be
at least equal to the maximum speed marked on the
power tool. Grinding accessories running faster than
>The outside diameter and the thickness of your
accessory must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
>The arbour size of wheels, sanding drums or any
collet of the power tool. Accessories that do not match
the mounting hardware of the power tool will run out
of balance, vibrate excessively and may cause loss of
control.
>Mandrel mounted wheels, sanding drums, cutters
or other accessories must be fully inserted into the
collet or chuck.
or the overhang of the wheel is too long, the mounted
wheel may become loose and be ejected at high velocity.
Safety information
GB
IE
07