Titan TTB863MLT Manual page 30

Operation
GB GB
IE
IE
Handling
>
application and switch it on.
> Wait until the tool attachment has reached its full speed before applying it to
the workpiece.
> Move the product slowly toward the work piece.
> Work with steady, careful movements.
> Observe the work piece and the tool attachment.
Work positioning
Depending on the application, the product must be held in different positions in
order to work safely and reach optimal work results.
>
> Hold the product like a hammer shaft for coarse work such as with a cutting
disc (Fig. 12).
WARNING! Switch the product off, let it come to a complete stop and
disconnect it from the power supply if the attachment gets stuck in the
workpiece. Only then free the jammed attachment.
After use
> Switch the product off, disconnect it from the power supply and let it cool down.
> Check, clean and store the product as described below.
30
Fig. 11
TTB863MLT by TITAN
1).
Fig. 12