Titan TTB863MLT Manual page 13

TTB863MLT by TITAN
operations
>Be aware that wire bristles are thrown by the brush
even during ordinary operation. Do not overstress
the wires by applying excessive load to the brush.
The wire bristles can easily penetrate light clothing and/
or skin.
>Allow brushes to run at operating speed for at least
one minute before using them. During this time no
one is to stand in front or in line with the brush. Loose
bristles or wires will be discharged during the run-in time.
>Direct the discharge of the spinning wire brush away
from you. Small particles and tiny wire fragments may
be discharged at high velocity during the use of these
brushes and may become imbedded in your skin.
Safety warnings for bonded abrasive wheels
>General
Abrasives are breakable and shall therefore be handled
with utmost care! The use of damaged or improperly
mounted or used abrasives is dangerous and can cause
serious injuries.
>Delivery, handling and storage
Abrasives shall be handled and transported with care.
Abrasives shall be stored in such a manner that they
are not subjected to mechanical damages and harmful
>Selection of abrasives
Information on the label or the abrasive as well as
restrictions of use, safety indications or any other
instruction shall be followed. In case of doubt concerning
the selection of abrasives, the user shall request
information from the manufacturer or supplier.
Safety information
GB
IE
13