P4 Throttle Startup Setting - KUNTENG KT-LCD4 User Manual

P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "imitation torque control" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "speed control" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press button (UP) or
After finishing P3 parameter setting, press
values, then enter P4 parameter setting interface.
○

P4 Throttle Startup Setting

Enter P4 parameter setting interface, P4 parameter column flashes.
ELECTRIC BICYCLE METER KT—LCD4 Product User Manual
P3 parameter setting interface
button (DOWN) for selection.
button (SW) to save the current set
- 21 -