P3 Power Assist Control Mode Setting; P4 Throttle Startup Setting - KUNTENG KT-LCD11 User Manual

ELECTRIC BICYCLE METER KT—LCD11 Product User Manual
Please Note：when P2 parameter is set to be 0, for the built-in clutch motor, there will
be the following defects, when the internal motor rotors stop or the internal rotor speed is
lower than the outer rotor speed, then the speed displayed on the meter is inaccurate!
After finishing P2 parameter setting, press
values, enter P3 parameter setting interface.
○

P3 Power Assist Control Mode Setting

Enter P3 parameter setting interface, P3 parameter column flashes.
P3 is power assist control mode setting, when P3 parameter setting is1, power assist
control mode is gear 5 of "imitation torque control" mode, when P3 parameter setting is
0, power assist control mode is gear 5 of "speed control" mode. P3 parameter needs to be
determined according to the distributed function of the controller, its setting range is 0 or 1,
press button (UP) or
After finishing P3 parameter setting, press
values, then enter P4 parameter setting interface.
○

P4 Throttle Startup Setting

Enter P4 parameter setting interface, P4 parameter column flashes.
P3 parameter setting interface
button (DOWN) for selection.
- 18 -
button (SW) to save the current set
button (SW) to save the current set