Daikin 2MXS-W Series Service Manual page 62

Functions for Wall Mounted / Floor Standing Type
Airflow Selection
FVXS Series
Airflow direction can be set with the airflow selection switch.
Setting
 Open the front panel.
Caution
Before opening the front panel, be sure to stop the operation and turn the breaker off.
Do not touch the aluminum fins (indoor heat exchanger) inside the indoor unit, as it may result in
injury.
When setting the airflow selection switch to
 The air conditioner automatically decides the appropriate blowing pattern depending on the
 During dry operation, air is blown from upper air outlet, so that cold air does not come into direct
When setting the airflow selection switch to
 Regardless of the operating mode or situation, air is blown from the upper air outlet.
 Use this switch when you do not want air coming out of the lower air outlet (e.g., while sleeping).
56
Front panel
operating mode/situation.
Operating mode
When the room has become
fully cool, or when 1 hour has
passed since turning on the air
conditioner.
Cooling operation
At the start of operation or when
the room is not fully cooled.
Normal time
Heating operation
At the start or when air
temperature is low.
contact with people.
„
Air is blown from the upper outlet only.
The blow pattern is automatically decided
„
depending on mode and conditions.
(Recommended and factory set.)
.
Situation
Air is blown from the upper air
outlet, so that air does not come
into direct contact with people,
and room temperature is
equalized.
Air is blown from the upper and
lower air outlets for high speed
cooling during cooling operation,
and for filling the room with
warm air during heating
operation.
Air is blown from the upper air
outlet, so that air does not come
into direct contact with people.
.
SiUS122226E
(R17866)
Blowing pattern
(R17867)
Part 4 Functions and Control