Address Space - Siemens SIMATIC ET 200SP Manual

Parameters/address space

4.3 Address space

4.3 Address space
The module can be configured differently in STEP 7; see following table. Depending on the
configuration, additional/different addresses are assigned in the process image output/input.
Configuration options of DQ 16x24VDC/0.5A BA
You can configure the module with STEP 7 (TIA Portal) or with a GSD file. If you configure
the module by means of a GSD file, the configurations are available under various short
designations/module names; see the table below. The following configurations are possible:
Table 4- 2 Configuration options with GSD file
Configuration
1 x 16-channel without value
status
Address space
The figure below shows the assignment of the address space for DQ 16x24VDC/0.5A BA.
Figure 4-1
18
Short designation/module
name in the GSD file
DQ 16x24VDC/0.5A BA V0.0
Address space DQ 16×24VDC/0.5A BA
Configuration software, e.g., with STEP 7 (TIA Portal)
Integrated in hard-
ware catalog PROFINET IO
STEP 7
V14 or higher with
HSP 0230
DQ 16x24VDC/0.5A BA digital output module (6ES7132-6BH00-0AA0)
GSD file GSD file
PROFIBUS DP
X X
Manual, 02/2018, A5E42404662-AA