Table of Contents
Advertisement
Press the lock release button (1) on the front of the dock's column, and then lift the mobility head unit
▲
(2) off the dock.
Attaching an I/O connectivity base to the mobile system
You can attach an I/O connectivity base to the bottom of the stand.
To attach an I/O connectivity base:
1.
Turn off the mobility system properly through the operating system, and turn off any external devices.
2.
Disconnect the power cords from the mobility system and I/O connectivity base.
IMPORTANT:
the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components.
3.
Remove the cover from the I/O connectivity base by removing the four screws on the underside of the I/O
connectivity base (1) and then lifting the cover off the I/O connectivity base (2).
Regardless of the power state, voltage is always present on the system board as long as
Attaching an I/O connectivity base to the mobile system
15
Advertisement
Table of Contents
