Table of Contents
Advertisement
6.
To connect and secure the USB Type-C power cable, attach the cable clip to the cable (1), insert the cable
tie into the hole (2) below the USB Type-C port on the I/O connectivity base, and then slide the cable clip
onto the cable tie and connect the cable to the port (3).
7.
Connect the AC adapter to the I/O connectivity base and a grounded AC outlet. See
adapter to power on page
Connecting a standalone I/O connectivity base to the mobile
system
You can connect a standalone I/O connectivity base to the mobile system.
To connect a standalone I/O connectivity base:
1.
Turn off the mobility system properly through the operating system, and turn off any external devices.
2.
Disconnect the power cords from the mobility system and I/O connectivity base.
IMPORTANT:
the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components.
3.
Connect the USB Type-C power cable to the USB Type-C port on the underside of the stand's column and
to the USB Type-C power port on the I/O connectivity base.
9.
Regardless of the power state, voltage is always present on the system board as long as
Connecting a standalone I/O connectivity base to the mobile system
Connecting an AC
17
Advertisement
Table of Contents
