Configuring Stop Of The Fuel Save Controller Via Switch Input Di 7 - SMA FUEL SAVE CONTROLLER 2.0M User Manual

SMA Solar Technology AG
Procedure:
1. Choose the menu Configuration Wizard via the page and menu selection.
2. In the Measurement System bar, press [Adjust].
3. Set the parameters in the menu Measurement devices general configuration (see Section 4.8.3, page 19).
4. Press [Continue wizard].
5. Set the parameters in the menu Measurement Devices configuration Wizard (see Section 4.8.3, page 19).
6. To add a device, perform the following steps:
• Choose the appropriate subsystem via Select a Subsystem.
• Choose the appropriate device (e.g., a load) via Select a measurement point.
• Press [Add].
• Press [Apply].
7. To remove a device, perform the following steps:
• Choose the appropriate device (e.g., a load) via Selected measurement points.
• Press [Remove].
• Press [Apply].
8. To continue with system settings, press [Continue wizard].
9. To end system settings, press [Done].
7.5

Configuring Stop of the Fuel Save Controller via Switch Input DI 7

The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode.
User Manual
7 System Settings
FSC20-BA-en-10 47