SMA Solar Technology AG
7 System Settings
7.1
Configuring the Utility Grid
The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode.
Requirement:
☐ You must be logged in as Installer.
Procedure:
1. Choose the menu Configuration Wizard via the page and menu selection.
2. In the Grid bar press [Adjust].
3. To activate the utility grid connection, set the parameter Enable to Yes.
4. To deactivate the utility grid connection, set the parameter Enable to No.
5. Press [Apply]. This will adopt the setting.
7.2
Configuring Gensets
The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode.
The system settings for the gensets are located in the menus Genset general configuration and
Generator configuration Wizard: detailed configuration. The displayed parameters depend on which gensets
are used.
User Manual
7 System Settings
FSC20-BA-en-10
37