Remote Base Hardware Overview - Savant REM-1000 Deployment Manual

4 Remote Base Hardware Overview
The REM-1000 includes a Pro Remote and Pro Remote Base. The Pro Remote communicates with its Base using
Bluetooth and the Pro Remote Base communicates with the Savant Control system using the local Wi-Fi network.
A Status LED, situated on the bottom of the Pro Remote Base, informs a user of the state of the Pro Remote Base.
The LED states are described below.
Pro Remote Base LED States
Off: No Power.
On Solid (Yellow): The Base is booting.
Blinks Once (Yellow): The Base is in Access Point Provisioning Mode and ready to be provisioned to
the local network.
Blinks Once (Green): The Base is provisioned to the local network but not communicating with the
Savant Host.
On Solid (Green): The Base is provisioned to the local network and communicating with the Savant
Host.
Rapid Blink (Red): If the reset button on bottom of Base is held down for at least five seconds, the
LED will begin a rapid blink (red). When button is released, the Base will reboot to its factory default
settings. At this point, the LED blinks yellow once per second indicating is in Access Point Provisioning
Mode.
Rapid Blink (Yellow): The locate feature was activated. From the SmartConnect App, tapping the
Remote Base entry in the Devices in Bluetooth section activates the locate feature. Refer to the
Connect to Wireless Network - SmartConnect
Blinking Yellow/Green: Firmware is updating on the Base.
REM-1000-01 Pro Remote Deployment Guide
009-1398-01 | 161020
section step 4 below for more information.
7 of 20
Copyright © 2016 Savant Systems, LLC