Buffalo TeraStation 3000 User Manual page 224

LCD Message
I36 Drivex
Decryption Error
I37 Recovering
System...
I38 Recovery
Finished
I39 Change Boot
Switch Back
I40 All Data Will Be
Deleted
I41 Push Func to
Start Recovery
I42 Preparing
Recovery
I43 Unsupported
Hardware
I44 Drive 1 Not
Found
I45 Recovery Failed
I46 Migrating RAID
Arrayx...
I47 Don't Power Off
System!
I48 Push Func to
Start Failover
I49 Lost Failover
Main
I50 Failover in
Maintenance Mode
I51 Initializing
Failover...
I52 New Firmware
Available
I54 Backup Jobxx
Failed
I55 Recovery Not
Authorized
Description
The media cartridge cannot be decrypted.
The media cartridge may have been
encrypted by a TeraStation other than this
product.
System recovery in progress.
System recovery is complete.
System recovery from the USB recovery
device is complete.
Beginning recovery. All data on the drive
will be deleted.
Press the function button on the front to
start the recovery process.
Preparing to start the recovery process.
The TeraStation was started from the USB
recovery device, but the system cannot be
recovered from this USB recovery device.
Recovery from the USB recovery device
was initiated, but drive 1 was not detected.
Recovery failed.
Data migration or conversion (RAID
migration) is in progress.
This TeraStation is ready to become the
failover backup for the main TeraStation.
The main TeraStation in the failover
configuration cannot be found.
Failover maintenance is in progress.
Initializing the failover configuration.
A new firmware version has been released.
The backup job failed.
Authentication during recovery of settings
failed.
Corrective Action
Connect the drive to the TeraStation that
performs encryption to decrypt the drive.
-
-
Change the boot mode switch on the rear
to "HDD".
-
-
-
-
Make sure that drive 1 is present and fully
inserted in its slot.
-
Do not turn off the TeraStation's power.
Hold down the function button on the
front of the target TeraStation until it stops
beeping to accept failover backup status.
Make sure that the main TeraStation is on,
working, and connected to the network.
Do not turn off the TeraStation's power.
Do not turn off the TeraStation's power.
Update the firmware.
Make sure that the backup job is
configured correctly. Make sure that the
NAS is on and not in standby mode. If the
backup job still fails, check the status of
NAS, network, and backup source and
destinations.
Settings can only be restored for the
TeraStation whose settings were originally
saved. To restore settings, insert the USB
memory device, move the Boot Mode
switch on the rear of the TeraStation to the
USB position, and restart the TeraStation.
Or, settings can be restored from Settings
with the TeraStation powered on.
223