3
Click Edit Failover Status.
4
Select a TeraStation to be the backup destination device.
5
Enter the administrator password of the backup destination device, then click Continue.
6
If the administrator password is correct, the backup TeraStation will beep. To accept the settings from the main
TeraStation, press and hold the function button on the front of the backup TeraStation until it stops beeping.
7
The I51 message will display on the LCD panel and NAS Navigator2 for both TeraStations. Wait until failover is
configured after it finishes and the I51 message disappears.
When failover is configured, the RAID array on the backup TeraStation may be reconfigured and
resynchronized to the same mode with the main TeraStation as part of the failover configuration process. This
is expected behavior and not an error.
8
To avoid a possible IP conflict after failover occurs, configuring a service IP address from the main TeraStation's
Settings is recommended.
101