Configuring Access Control - Nokia 7368 Product Manual

Configure a G-2426G-A indoor ONT
Security configuration

Configuring access control

4
Configure the following parameters:
Table 7-29 DMZ parameters
Field
ALG Config
DMZ Config
WAN Connection List
Enable DMZ
DMZ IP Address
5
Click Save DMZ.
E
ND OF STEPS
7.35 Configuring access control
This procedure describes how to configure the access control level (ACL).
Note: ACL takes precedence over the firewall policy.
The trusted network object will be shared for all WAN connections; it is not applied individually
to a WAN connection.
1
Click Security Access Control from the left pane in the GPON Home Gateway page. The
Access Control page displays.
September 2020
Issue 1
Description
Select the checkboxes to enable the protocols to be supported by the ALG: FTP, TFTP, SIP, H323,
RTSP, L2TP, IPSEC, PPTP.
Select a WAN connection from the list.
Select this checkbox to enable DMZ on the chosen WAN connection.
Select Custom Settings and enter the DMZ IP address or select the IP address of a connected
device from the list.
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-XXXXX-AAAA-TCZZA
7368 ISAM ONT
133