Adding New Qc Lots - Siemens Healthineers Atellica VTLi User Manual

‒ Tap User to select results from a specific user. Tap the user from the list, or select Any User to
see all user results.
‒ Tap Cartridge Type to select results for a specific cartridge type. Tap a cartridge type from the
list, or select Any Cartridge to see all cartridge results.
3. Do one of the following:
to return to the Results Review screen.
‒ Tap
‒ Tap Default to reset the filter to the factory setting.

Adding new QC lots

Once a new QC lot is registered, it can be released for use by performing a QC test on the analyzer.
Registering a new lot can be done by an Admin on the analyzer or by using the service software.
Refer to the Atellica VTLi Advanced User Guide for details on using the service software.
INSTRUCTIONS
Unless the lot is registered with the service software, only an Admin user can perform the
procedure below.
1. On the Home screen, tap the assay button to display the current lots.
2. Tap the lot you want and then tap Register a new cartridge/QC lot.
3. Tap Start Quality Control (QC).
4. Scan the QC vial barcode.
The barcode contains the QC reagent lot ID and expiration date. The analyzer confirms the QC
lot ID number.
5. Confirm the lot and level information and then tap Scan.
Refer to the Instructions for Use included with the quality controls for the lot acceptance
6. Follow steps 4 - 11 on page 27.
If the Lot Management feature is enabled in the service software, the new registered QC lot is
available for other analyzers in a group after synchronization.
Chapter 3 - Performing Quality Control
29