General Installation Steps - Siemens SITRANS WS300 Operating Instructions Manual

Installing/mounting

3.7 General installation steps

3.7 General installation steps
1. Drill out pulley shaft to a depth of 64 mm (2.5 inch) concentric to its centerline.
Remain within specified tolerances
Exercise caution and remain within specified tolerances.
2. Drill out and thread the set screw hole.
Dimensions in mm (inch)
① M8 x 1.25 (5/16-18 UNC) set screw (by customer)
② 16.00 mm (0.630 inch) dia., 16.07 mm (0.633 inch)
3. Attach angle iron bracket to work with the arrestor rod (if mounting on a tail pulley).
4. Cut the arrestor rod to a suitable length.
14
WARNING
Operating Instructions, 04/2021, A5E45050935-AC
SITRANS WS300