Table of Contents
Advertisement
Available languages
Available languages
Installation Steps
RBSS without mounting bracket
1.
Measure the distance between the inside of the conveyor stringers, and then cut
the 24 mm (1") cross bar to the measured length.
2.
Orient the Return Belt Speed Sensor as shown in the "RBSS without mounting
bracket" on page 4.
3.
Slide the cross bar through the hole on the end of the Return Belt Speed Sensor, and
then slide one 24 mm (1") washer onto either end of the cross bar.
4.
Position the assembly so the sensor wheel rides in the middle of the return belt.
5.
Make sure there is 3 mm (1/8") clearance between the sides of the sensor and the
washers, and then tack-weld the washers to the cross bar.
6.
Tack-weld one end of the cross bar to one stringer.
7.
Square the entire assembly with the return belt so the wheel will ride straight.
8.
Tack-weld the other end of the cross bar to the opposite stringer, making sure the
assembly remains square with the belt.
stringer
tack-weld
return belt
9.
Run the belt to check that the wheel is riding straight on the belt and is not pulling to
either side. If necessary, break one weld and pivot the entire assembly until the
wheel runs true.
RBSS with mounting bracket
1.
Position the RBSS mounting bracket against a structural cross member so the
sensor wheel rides in the middle of the return belt. See the "RBSS with mounting
bracket" on page 4.
2.
Drill and fasten or tack-weld the RBSS mounting bracket in place.
3.
Position the RBSS between the bracket arms, and insert pin. Insert pin clip into pin.
4.
Run the belt to check that the wheel is riding straight on the belt and is not pulling to
either side. If necessary, reposition the bracket until the wheel runs true.
7ML19985GX63
RBSS Speed Sensor – INSTRUCTION MANUAL
RBSS
washers (2 places)
cross bar
Page EN-5
Advertisement
Table of Contents
