Installing/mounting
3.7 General installation steps
Dimensions in mm (inch)
①
M12 x 1.75
②
Set screw
Note
All other installation instructions apply. See General installation steps (Page 14).
3.7
General installation steps
1. Drill out pulley shaft to a depth of 64 mm (2.5 inch) concentric to its centerline.
2. Drill out and thread the set screw hole.
Dimensions in mm (inch)
①
②
3. Attach angle iron bracket to work with the arrestor rod (if mounting on a tail pulley).
4. Cut the arrestor rod to a suitable length.
14
WARNING
Remain within specified tolerances
Exercise caution and remain within specified tolerances.
M8 x 1.25 (5/16-18 UNC) set screw (by customer)
16.00 mm (0.630 inch) dia., 16.07 mm (0.633 inch)
③
M12 x 1.75 [use adhesive when installing
threaded shaft coupling (e.g. Loctite)]
Operating Instructions, 08/2020, A5E45050935-AB
SITRANS WS300