Putting The Radar Into Standby - Raymarine LIGHTHOUSE SPORT 3.18 Operation Instructions Manual

1. Ensure your radar scanner is compatible, check the latest details
available on the Raymarine website, if in doubt please contact an
authorized Raymarine dealer for advice.
2. Ensure you have installed your radar scanner in accordance with the
documentation that was supplied with your Radar.
The Radar app will open in one of the following states:
Off/Not Connected
If the 'Off/Not Connected' message is displayed then the display cannot
establish a connection with your radar scanner:
Ensure that your display and radar scanner are paired correctly and then
select [On] to power up your radar.
If the 'Radar not found' message is displayed then power cycle your
system and perform the pairing procedure again. If the radar scanner still
cannot be found refer to your Radar's installation documentation for further
troubleshooting information.
Off
If the 'Off' message is displayed then your radar scanner is powered off,
select [On] to power up your Radar
120
Standby (Not transmitting)
If the 'Standby' message is displayed then select [Transmit] to begin
transmitting.
Transmitting
If your radar scanner is connected, powered up and transmitting then the
radar image is displayed and echoes returns are displayed onscreen.

Putting the radar into standby

With your selected radar displayed onscreen:
1. Select [Transmit] from the main menu.
The radar scanner will stop transmitting and is put into standby mode.