Step 3 - Plug The Cables Into The Sportpilot - Raymarine SportPilot Owner's Handbook Manual

81057_6.book Page 42 Tuesday, February 21, 2006 2:21 PM
42
16. Remove the template and smooth any rough edges.
Step 3 – Plug the cables into the SportPilot
1. Pass the plugged ends of the power, compass, rudder position sensor (if fitted)
and SeaTalk cables (if required) through the aperture.
SeaTalk cable (3-core)
Power cable (5-core)
Note: basic installations will only have power and compass cables
Reposition the suppression ferrites so that they are located behind the bulkhead. In
Note:
certain situations you need to remove the ferrites from the cable and re-fit them at the end
of installation.
2. Cut the cable sealing mat must be cut (as shown) with a knife to allow the
plugged cables to pass through it.
ST60 Tridata Instrument Owner's Manual
Rudder reference cable
Compass cable
D1366-2
D1367-2