Download Print this page

Revopoint 3D Technologies POP 2 User Manual page 18

Table of Contents

POP 2 3D Scanner User Manual

After clicking Stop, it is possible to resume scanning (say, after repositioning either the POP/POP 2 or the object being

scanned). If this is desired, then be sure to move the slider switch for "Fuse point cloud immediately?" to the right before

clicking "Complete". The scan data will be fused into a point cloud immediately. After this, meshing the point cloud data or

resume scanning are available.

Inactive button in the Stop's popup (so that Fusing is a manual operation, allowing changes in the preset):

Table of Contents

Need help?

Do you have a question about the POP 2 and is the answer not in the manual?