Advertisement
B
A
D
B
A
A
B
C
Install the below flange bolt (A) from rear to
front, and then tighten the nut (B) to 450~550
kgf-cm torque.
3. Rear A-arm Protector Cover
There are marks (LH / RH) inside the a-arm
protector cover, according to the mark to
assemble the protector cover to the
corresponding a-arm.
4. Wheels
Install the wheel, make sure the air valve is
facing out, and the arrow mark (if exist) on
the tire point toward to rotating direction
of the wheel. Tighten the nuts (A) with
680~720 kgf-cm tighten torque and then
plug the rubber cap (B).
Warning
Install the nut with its tapered side towards
the wheel.
5. Handlebar
Place the bottom bracket (A) on the shaft
axle, and pre-fix the handlebar on the
bottom bracket by handlebar brackets (B).
Adjust the handlebar to the center position,
and align the punch mark (C) on the handle
bar with the hole (D) on the handlebar
upper bracket to get the correct assembly
angle. Tighten the front bolts of the holder
first and then the rear bolts. The tighten
torque specification is 300~350 kgf-cm.
13
Hide quick links:
Advertisement
