Advertisement
A
A
B
Assemble the master cylinder on the left
handlebar and close to switch assy., and
A
make the top cover of the master cylinder
parallel to the ground. And then tighten the
bolt on the upper side of the master cylinder
bracket, and then the lower side bolt. Make
sure the "UP" mark (A) on the bracket is
pointed upwards.
6. Handlebar Cover / Hand Guard
Take off the 5 bolts on the handlebar
bottom bracket, and assemble the rear
handlebar cover comp. to the bottom
bracket by those bolts. Before assembling,
connect all the corresponding wires
according to the wire color. It includes the
speedometer wires, main switch wires and
rear differential controller wire.
Fix the LH hand guard bracket (A) on the
master cylinder by the right-handed thread
bolt, and fix the RH hand guard bracket on
the bracket located at the right handlebar
by the left-handed thread bolt. Place the
washers between the bolts and bracket to
get more effective area.
Assemble the front handlebar cover to the
rear cover comp., with the tapping screws
(the 12mm length screws (A) are used for
the inner fixing points, and the 16mm
length screws (B) are used for the outer
fixing points). And then use the flange
screws to fix the front cover and the
brackets.
Note
Releasing the bracket of master cylinder
and the bracket located on left handlebar,
and adjust the angle to achieve better
assembly adaptation.
14
Hide quick links:
Advertisement
