Table of Contents
Advertisement
Hazardous Radiation Exposure
•
•
Installation Procedure Overview
The installation procedure of ConnectX-6 Dx adapter cards for OCP Spec 3.0 involves the following
steps:
St
ep
1
Check the system's hardware and software
requirements.
2
Pay attention to the airflow consideration within the
host system
3
Follow the safety precautions
4
Follow the pre-installation checklist
5
(Optional) Replace the assembled OCP 3.0 bracket
with the desired form factor bracket
6
Install ConnectX-6 Dx adapter card for OCP spec 3.0
in the system
7
Connect cables or modules to the card
8
Identify the ConnectX-6 Dx adapter card in the
system
System Requirements
Unless otherwise specified, NVIDIA products are designed to work in an environmentally
controlled data center with low gaseous and dust (particulate) contamination levels.
The operating environment should meet severity level G1 as per ISA 71.04 for gaseous
contamination and ISO 14644-1 class 8 for cleanliness level.
Caution – Use of controls or adjustment or performance of procedures other than
those specified herein may result in hazardous radiation exposure.For products with
optical ports.
CLASS 1 LASER PRODUCT and reference to the most recent laser standards:
IEC 60 825-1:1993 + A1:1997 + A2:2001 and EN 60825-1:1994+A1:1996+ A2:20
Procedure
Direct Link
Refer to
System Requirements
Refer to
Airflow Requirements
Refer to
Safety Precautions
Refer to
Pre-Installation Checklist
Refer
to OCP 3.0 Bracket Replacement
Instructions
Refer to
Installation Instructions
Refer to
Cables and Modules
Refer to
Identify the Card in Your System
22
Advertisement
Table of Contents
Troubleshooting
