Subscribe to Our Youtube Channel
Related Manuals for Mountup MU2001
Summary of Contents for Mountup MU2001
- Page 1 Polished Aluminium Single Monitor Wall Mount Instruction Manual 75x75 32" 100x100 1.5~8kg 3.3~17.6lbs If you have any questions , please contact our customer service. TPM-MA05-112W-US1.0...
-
Page 2: Package Contents
WARNING! If you have any confusions or are not quite sure about the installation, please do not hesitate to ask for our help. Before assembly, please check and make sure all necessary accessories are included and undamaged. Improper installation, such as use the product for monitors over its load capacity or for any purpose not explicitly speci ed, may cause damage or serious injury. -
Page 3: Assembly Steps
ASSEMBLY STEPS STEP 1: Attach Arm Assembly to Wall OPTION A: Wood Stud Installation Position the Arm Assembly (A) at your desired height and line up the holes with your stud center line. Level the Arm Assembly (A) and mark the pilot hole locations. - Page 4 STEP 1: (Continued) OPTION B: Solid Concrete Wall Installation Position the Arm Assembly (A) at your desired height , level the Arm Assembly (A) and mark the pilot hole locations. 60mm (2.4") ø10mm Drill pilot holes using a ø3/8 in. (ø...
- Page 5 STEP 2: Attach Decorative Cover Attach Decorative Covers (D) to Lag Bolts (W-A).
- Page 6 STEP 3 : Attach Monitor OPTION A: Flat Back Monitor Attach the VESA plate (B) to back of monitor and Monitor Monitor Monitor secure with screws(M-A)or(M-C) with washers(M-E) using 6 mm Allen Key (E). Do not tighten the screws excessively or your monitor might be damaged. OPTION B: Curved Back Monitor Monitor Monitor...
- Page 7 STEP 4: Hang Monitor Slide the monitor onto the head of swivel arm, install the security bolt (C). Make sure the security bolt is installed before you rotate the monitor. Important Notice: The gas spring is pre-set to minimum tension. Once the monitor is hanged on, hold the monitor with both hands and DO NOT let go suddenly or immediately.
-
Page 8: Step 5: Adjust Tension
STEP 5: Adjust Tension For intended functioning of the mount, you may need to adjust the tension of Upper Arm (A) in accordance with your monitor weight by 6 mm Allen Key (E). CAUTION Note1: Be sure to keep the arm in horizontal position during adjustment. Situation 1: Arm falls down Upper Arm with monitor falls down and fails to stay where intended. -
Page 9: Step 6: Cable Management
STEP 5: (Continued) STEP 6: Cable Management Attach Cable Cover For lower arm: Insert the cable and slide the cable cover down; For upper arm: Insert the cable and press the tabs on the inside of the cable cover slightly inward and slide down to reattach the cable cover. - Page 10 Adjust as Desired Adjust monitor position and rotation. Tilt Swivel Rotation Height Swivel 180° +90° Tilt -45° 360° Swivel Rotation 360° Swivel Height 180° Note: To ensure stability, the tightness of the rotating axis has been preset, so it would be kind of di cult to rotate the VESA plate. Suggestion: Please attach the monitor rst, then hold the two sides of it with both hands, and rotate vigorously.
-
Page 11: Product Dimensions
Product Dimensions 8.7"-10.8" 180° 360° 360° 180°... - Page 12 CAUTION AND MAINTENANCE: • Never allow children to climb, stand, hang, or play on any part of monitor or stand. • This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury. •...
Need help?
Do you have a question about the MU2001 and is the answer not in the manual?
Questions and answers