Addi-Data ADDINUM PA 1500 Technical Description page 24

Software
Interrupt:
Used interrupt of the board. If the board supports no interrupt, the message
"Not available" is displayed. For PCI boards the interrupt is allocated
through BIOS.
WICHTIG!
i
The interrupt set in ADDIREG must correspond to the one set
through jumper.
ISA DMA (ISA boards only):
Indicates the selected DMA channel or "Not available" if the board uses no
DMA or if the board is no ISA board.
More information:
Additional information like the identifier string or the installed COM
interfaces. It also displays whether the board is programmed with
ADDIDRIVER or if a PCI DMA memory is allocated to the board.
Text boxes:
Base address name:
Description of the used base addresses for the board. Select a name through
the pull-down menu. The corresponding address range is displayed in the
field below (Base address).
Base address:
In this box you can select the base addresses of your PC board. The free
base addresses are listed. The used base addresses do not appear in this box.
Interrupt name:
Description of the used IRQ lines for the board. Select a name through the
pull-down menu. The corresponding interrupt line is displayed in the field
below (Interrupt).
Interrupt:
Selection of the interrupt number which the board uses.
DMA name (for ISA boards only):
When the board supports 2 DMA channels, you can select which DMA
channel is to be changed.
DMA channel (for ISA boards only):
Selection of the used DMA channel.
Buttons:
Edit:
Selection of the highlighted board with the different parameters set in the
text boxes.
24
PA 1500