Table of Contents
Advertisement
6. SAFETY PRECAUTIONS
This shrinking device is only intended for professional use.
•
Take care to use the correct power supply : the Easyshrink
•
60 Hz. Power supply for the optional cooling modules is : 1x230V + PE/16A/50-60Hz. Use optional transformers to
accommodate shop electric service from 190 to 510V 3X in USA or CSA for Canadian voltage. Both transformers output
1x230V+PE/16A/50-60Hz for support modules.
By nature on, the Shrinkfit holder becomes very hot. Touching this spot may cause serious burns. Always use gloves
•
when handling shrink fit holders.
Individuals who carry medical implants are banned from using or working with this device. The carriers of a pacemaker
•
must refer to the specific note of the pacemaker established on the basis of: NF EN 60601-1-2 (september 2007).
Repairs on the Shrinking devices must be made only by skilled operators. Please contact your local Seco representative.
•
Only trained and authorized persons are allowed to work on the shrinking devices.
•
The optional cooling modules are not switched off by the Easyshrink
•
handling, it's necessary to switch off the power supply using each module's interrupter.
7. RECOMMENDATIONS FOR USE AND MAINTENANCE
Always make sure the holder is cooled down before shrink-fit, or shrink-release.
•
The holder and the tool must be clean, free from grease and dry before being fitted into the device.
•
Before starting the shrinking process, please always check if :
•
o the power supply is sufficient
o the length has been correctly setted, with the correct stop rod
o the correct diameter is selected (mode PRG 1 or PRG 2)
o the correct heat focusing stopper has been setted
o the tool shank is within tolerance h5-h6
o the tool shank is not damaged
Keep the device and its environment clean, to insure a long service life.
•
The device can only be used for the purposes defined in this operating book. Seco Tools AB. cannot be held as
•
responsible for casualties caused for any other use.
Maintenance is limited on a regular cleaning of the device and accessories with adapted products.
•
8. SAFETY FUNCTIONS OF THE EASYSHRINK
The inductor is equipped with a probe to avoid overheating of the holders.
•
To increase service life of the holders, the electronic of the device has been programmed to allow only one main heating
•
process, afterwards it automatically cuts off.
9. APPENDICES
9.1.
Technical features
Voltage
Intensity
Frequency
Dimensions L x H x D
Weight
Temperature Air humidity Air pressure
Usage
10 to 40°C
Storage
-20 to 55°C
Transportation
-20 to 70°C
3 x 400 V (+/-10%) + PE
16A
50-60Hz
840 x 880 x 400 mm
50 Kg
10 to 90%
800 to 1013 hPa
(1)
30 to 95%
800 to 1013 hPa
30 to 95%
800 to 1013 hPa
(2)
15 device must be connected on AC 3x400V + PE/ 16A/ 50-
®
15's main interrupter (red power switch). Before any
®
®
15
Prevent condensation and frost
(1)
(3)
Air humidity when the temperature of the device slowly
(2)
increases to 40° or quickly passes from -20 to +30°C
At max. 2000m above the sea level
(3)
22
Advertisement
Table of Contents
