Preparation Before Shrinking Cycle; Minimal And Maximal Shrinkfit Assembly's Height - Seco EASYSHRINK 15 Operating Instructions Manual

4.3.4. Preparation before shrinking cycle

1) Position the universal sliding support on the heating station.
2) Install on it the support ring that corresponds to the Shrinkfit toolholder's taper.
Please refer to the latest Machining Navigator 'Tooling Systems' or to the
Machining Navigator 'Update' to select the appropriate support ring.
3) Choose the adapted heat focusing stopper that corresponds to the tool shank
diameter.
Note: 5 heat focusing stoppers are supplied with each device, capacities: Ø 3-6,
Ø 8-14, Ø 16-18, Ø 20-25, Ø 32 mm.
4) Install it into the location diameter in the inductor housing. Turn it around to
lock it on the inductor housing.

4.3.5. Minimal and maximal shrinkfit assembly's height

Minimum height between
inductor and flange location
Maximum height between
inductor and main plate
Maximum 'A length' of the
assembly 'holder+tool'
16
Support ring
Universal
sliding
support
160 mm
620 mm
460 mm