Using The Device; Putting The Device Under Tension; Turning On The Device; Shrinking Procedure - Seco EASYSHRINK 15 Operating Instructions Manual

4. USING THE DEVICE

4.1.

Putting the device under tension

Switch on the main interrupter of the device.
On the keypad, the white LED will go on.
Display shows: POWER OFF.
4.2.

Turning on the device

Switch on the module by pressing key
Select the required mode on the control panel according to the Shrinkfit holder front end
type (see § 4.3.) and press key
Device is ready for a shrink grip or release heating cycle.
Switch off the control panel by pressing key
4.3.

Shrinking procedure

Wearing supplied protective gloves is imperative while handling the device

4.3.1. Description of the different heating modes

AUTOMATIC MODES:
User selects the required automatic mode on the control panel, no need to select the diameter.
CARBIDE 5800: optimised shrink grip & release of carbide and heavy metal tools in type 5800 holders
CARBIDE 5801: optimised shrink grip & release of carbide and heavy metal tools in type 5801 holders
CARBIDE 5603: optimised shrink grip & release of carbide and heavy metal tools in type 5603/5803 holders
CARBIDE 5600: optimised shrink grip & release of carbide and heavy metal tools in type 5600 holders
STEEL 5600: shrink grip & release of HSS and steel tools in type 5600 holders
STEEL 5800-5801-5603: shrink grip & release of HSS and steel tools in type 5800, 5801, 5603/5803 holders.
.
.
and Shrinkfit holders/tools.
13