SKF Lincoln J Series User And Maintenance Instructions
Air operated grease pump
Hide thumbs
Also See for Lincoln J Series:
- Installation instructions manual (20 pages) ,
- User and maintenance instructions (12 pages)
Related Manuals for SKF Lincoln J Series
Summary of Contents for SKF Lincoln J Series
- Page 1 User and maintenance instructions Air operated grease pump Model , series “J” Date of issue November Form number Version ...
- Page 2 Contents Declaration of Incorporation* .. U.K. Declaration of Incorporation* . . . Safety* .........
- Page 3 N. Hanley Road St. Louis, MO U.S.A. TEL: + () - FAX: + () - Authorized to compile the technical file: SKF Lubrication Systems Germany GmbH Heinrich-Hertz-Straße - Walldorf, Germany TEL: + () - EMAIL: robert.collins@skf.com WEBSITE: www.skf.com...
- Page 4 Lincoln Industrial Corporation N. Hanley Road St. Louis, MO U.S.A. TEL: + () - FAX: + () - Authorized to compile the technical file: SKF (U.K.) Limited Canada Close Banbury, Oxfordshire, OX RT, GBR EMAIL: robert.collins@skf.com WEBSITE: www.skf.com This U.K.
-
Page 5: Explanation Of Signal Words For Safety
Safety* Explanation of signal CAUTION Do not operate equipment without words for safety wearing personal protective gear. The assembly must be installed, maintained Wear eye protection. Protective and repaired exclusively by persons familiar equipment such as dust mask, non-skid with the instructions. -
Page 6: Fill Reservoir
Specifications Lubricant output Reservoir Air Lubricant Lubricant operating pressure Ratio Per cycle ) Per minute at psi (60 bar) capacity inlet outlet Type of system Minimum Maximum Recommended : . in in (197 cm lbs. ... - Page 7 Fig. Dimensions þþ ÿ þ þþÿ þþ þ þ ÿþþ þþ þ þ ÿÿþ þ þ þþ ) Vent valve () ...
-
Page 8: Prime System
Lubricate air valve Prime system Vent valve mechanism Vent valve () operates with compressed air Supply lines from same source that operates pump. Disconnect air to pump and remove Operate pump until lubricant starts to bleed When pump is in operation, air pressure four cover screws (), cover plate () around vent plug to expel air pockets keeps vent valve closed and lubricant is... - Page 9 Fig. IPB Model / in NPTF ) Air exhaust port ) Torque to in.lbf. (3,3 to 4,5 Nm). ) Torque to in.lbf. (10 to 12 Nm). ) Assemble with Loctite # Blue. ) Tighten to to ft.lbf. (27 to 33 Nm). ...
- Page 10 Fig. Model / in NPTF ) Tighten to to ft.lbf. (13,5 to 20,3 Nm). ) Torque to to ft.lbf. (128 to 142 Nm). ...
- Page 11 Service parts Item Description Qty. Part no. Item Description Qty. Part no. Item Description Qty. Part no. Gasket (nitrile) ° tube connector * Steel ball Retaining ring Vent valve assembly ...
-
Page 12: Troubleshooting
Troubleshooting Problem Cause Solution Pump operates continuously. Pump has lost prime. Examine lubricant supply. Refill reservoir if necessary. Air pocket trapped in lubricant. Loosen vent plug one turn. Allow pump to operate until trapped air is pumped out. Close vent plug. Pump continues to operate without discharging Pump check () and steel ball () Remove and clean checks and check seats. - Page 13 This page left intentionally blank. ...
- Page 14 This page left intentionally blank. ...
- Page 15 This page left intentionally blank. ...
-
Page 16: Warranty
® SKF and Lincoln are registered trademarks of the SKF Group. © SKF Group The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.
Need help?
Do you have a question about the Lincoln J Series and is the answer not in the manual?
Questions and answers