Advertisement
2. Load the film face down inside the template. The side of the template (which reads
"Microtek" logo) should face up. For details on how to load the different sizes of
film into the template, refer to other sections of this chapter.
3. [Optional] If the black plate* is available, slide it until its edge is against the film.
For details on the black plate, see page 14.
4. Place the template (side reading "Microtek logo" facing up) on the scanner glass
surface. Make sure that the template's front corners are firmly aligned against the
top ruler of the scanner, and that the two edges (left and right) fit within the
scanner glass area.
5. Gently lower the TMA1600 down onto the scanner glass surface.
Advertisement
