Advertisement
: To prevent damage to the TMA1600 moving parts, the TMA1600 carriage is
locked into place prior to shipment. You must unlock the carriage before starting to
operate the scanner. Failure to do so may damage the TMA1600.
To unlock the TMA1600, follow the steps below:
1. Look for the unlocking knob at the
base of the TMA1600.
2. Turn the locking knob
counterclockwise to the unlock
position " ".
If you have to transport the TMA1600, the TMA1600 must be locked. To lock the
TMA1600, follow the steps below:
1. Make sure the TMA1600 is connected to the scanner, then turn off the scanner if
your scanner is on.
2. Set the scanner SCSI ID number to "9".
3. Turn on your scanner. The TMA1600 carriage will move to the standby position in
5 minutes.
4. When the indicators on the
front of your TMA1600 and
scanner stop blinking, turn
the locking knob clockwise to
the lock position " " .
5. Turn off your scanner and
disconnect the TMA1600
connector from the scanner.
The TMA1600 is ready for
transport.
: To use the scanner again at a future time, be sure to reset the scanner ID to
its original number before step #2. Otherwise, the scanner ID will be left at SCSI ID
9 and will not work.
Advertisement
