Using The 4" X 5" Film Holder - Microtek ArtixScan 2500 User Manual

E. Using the 4 " x 5 " Film Holder
1. Insert the film to be scanned into the 4" x 5" Film
Holder.
a) Push on the side to open the holder.
b) Place the film in the holder.
c) Pull down the side to close the holder.
24 ArtixScan 2500 Installation and Operation Manual
Scanning in high resolution: Insert the film to be
scanned into the holder in the area labeled "HIGH
RESOLUTION" on the holder. High-resolution
scanning is at 2,500 dpi.
2. Pull the transparency tray out a little, then place the
4" x 5" Film Holder into the transparency tray. Make
sure the holder is seated firmly in the transparency
tray by pushing down on each corner of the holder
firmly.
3. Gently push the transparency tray back in.