Agilent Technologies 4107 User Manual page 18

Installation
3
4
5
6
Position the nitrogen generator to allow easy access to the power
button located on the front of the instrument.
Air supply hose
Fitting to air
compressor
Filtered air
supply input
Figure 3. Nitrogen generator tubing and power connections
18
While still attached to the rails, use an overhead or portable hand
crane and slings, thread the slings between the wheels and the
substructure, both front and back and then lift the nitrogen
generator.
Remove the pallet from underneath and then lower the nitrogen
generator to the floor.
Once the instrument is completely off of the pallet, unscrew the
three screws attaching the rail to the nitrogen generator.
The nitrogen generator can then be wheeled into position.
Power input
Nitrogen output
Agilent 4107 Nitrogen Generator User's Guide