Mode Change Screen - Toshiba GR-200 Series Instruction Manual

Figure 12.8-14 Setting menu after selecting "FSC01"
• ON: Forcibly set the transmission signal from non-generation to generation
• OFF: Forcibly set the transmission signal from generation to non-generation
• Normal:
Forcible set is not applied.
After the selection of the control style (selecting "FSP OP" in Figure 12.8-13), use
the following screen of Figure 12.8-15. Press [ENTER] key to start the control.
Figure 12.8-15 Start screen of forcibly control
TestFlag-EN screen
(iii)
This function can set all communication protocol Test flags to Test mode. The user should select
TestFlag-EN in Figure 12.8-1 and select On or Off.

Mode change screen

(iv)
When the user selects "Mode Change" from the Test sub-menu shown in Figure 12.8-1, the
following Mode change screen is displayed (Figure 12.8-16). This allows control from a remote
device (For example, SAS server) by configuring the MDCTRL-EN setting.
Figure 12.8-16 Mode Change sub-menu
FSC01-SET
10:48
Normal
Off
On
F. Signal Control
10:48
Press and hold ENTER
to operate
Press <- to return
to previous screen
Mode Change
10:48 1/3
MDCTRL-EN
Off
MDCTRL-SELRST
30
MDCTRL-EXERST +
30
- 905 -
1/3
+
+
s
s
6F2T0200 (0.15)
GRE200 (1,2)